This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Openplotter 3 64 bit - No Seatalk1, GPIO app unavailable.
#9
(2023-04-15, 11:26 AM)Sailoog Wrote: Yes, a lot of systems are already working.
Could you show the circuit you are using?

I followed the youtube tutorial and based on your positive reply dug a little deeper. 

I built a testsetup at home and guess what, it works fine! I did get it to work on the boat briefly but after a reboot things went silent again never to resurrect again.

Only difference between home and boat is the length of the wires, and my thought is that i made a mistake on the boat by placing the 4700 resistor far away from the optocoupler (~3 meters).

Sadly I can’t test this hypothesis for at least a few weeks since my calendar doesn’t allow for a lot of boat time.

Will for sure follow up here…
Reply


Messages In This Thread
Downgrade for seatalk to work? - by erpi1962 - 2022-10-24, 02:03 PM
RE: Openplotter 3 64 bit - No Seatalk1, GPIO app unavailable. - by broosmaxim - 2023-04-18, 10:31 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)