2023-05-16, 05:35 PM
(This post was last modified: 2023-05-16, 05:38 PM by Boatingbaileys.)
(2023-05-16, 05:30 PM)shinken Wrote:(2023-05-16, 05:24 PM)Boatingbaileys Wrote:(2023-05-16, 03:12 PM)shinken Wrote: I have a nice setup running based on OpenCPN/OpenPlotter/SignalK/KIP everything works when I log into my headless Raspberry Pi via VNC using a tablet but VNC is slow.
I would like to access KIP via my laptop. So I log into the Pi's WIFi HOTSPOT from my laptop. I can access SignalK using http://localhost:3000 from there I load the webapps and all of them (InstrumentPanel, Sailgauge, etc) work except for KIP. I can see the the KIP screen and displays I created but they contain no data and I get an http error.
Any experience with this?
Just check the address you are using to reach signalK from Kip. If you have loaded the same config that you would normally open on your Pi using your Laptop, chances are that its address for SignalK is also 'Localhost'. It will need to be changed to the PI ip with the same port. I have had to do this when i use KIP on my phone.
When you save this config, change its name from default, then you can load default on your pi and this one with the change address on your laptop could be 'laptop' for example.
I think I follow you. Thank you. I will try that.
I used http://10.10.10.1:3000 that has a conflict with KIP but not with SignalK. I have seen http://10.10.10.1:4200 listed for KIP. Which one is correct?
Just to be clear, this is in KIP settings, not the address to reach KIP.
If I understand correctly, you are on a laptop, connected to your PI WIFI and you have gone to KIP IP/port but that isn't getting any data?