2023-06-22, 10:22 AM
Hi, first part was already in config.txt, overlay for 1W:
dtoverlay=w1-gpio
And in Openplotter setting the default are pin 4 as it says. I added it anyway to config:
dtoverlay=w1-gpio,gpiopin=4
But same result. I now remembered that I have forgot the 4,7 kohm pullup, but it was working before without that.
When trying refresh in Openplotter GPIO settings, it also says GPIO disabled?
But startup check is ok?
/Leif
dtoverlay=w1-gpio
And in Openplotter setting the default are pin 4 as it says. I added it anyway to config:
dtoverlay=w1-gpio,gpiopin=4
But same result. I now remembered that I have forgot the 4,7 kohm pullup, but it was working before without that.
When trying refresh in Openplotter GPIO settings, it also says GPIO disabled?
But startup check is ok?
/Leif