This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
OpenMarine › OpenPlotter › How do I...? v
SH-RPi V1 OP 3RPI 4 cant get 1W to work

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
SH-RPi V1 OP 3RPI 4 cant get 1W to work
holgerw Offline
snorkel
****
Posts: 298
Threads: 4
Joined: Mar 2016
Reputation: 10
#4
2023-06-22, 12:09 PM (This post was last modified: 2023-06-22, 12:11 PM by holgerw.)
Is it enabled in raspi-config?

Get your Sensors gnd, data and +3.3 Volt?
Is there an Resistor of 2…5kohm between data and + 3.3 Volt?
Donautics
Website Find
Reply


Messages In This Thread
RE: SH-RPi V1 OP 3RPI 4 cant get 1W to work - by holgerw - 2023-06-22, 12:09 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)