2023-06-28, 09:11 PM
(This post was last modified: 2023-06-28, 11:25 PM by baltika_no_9.)
Excellent work, thank you
I notice that in the new 3.2.8 panel, the variables displayed include vendor,product,model whereas before it was vendor,product,serial. The latter ties in with the option to remember device (by vendor, product, serial). If I put two similar devices in, the vendor,product,model will be identical but even though the serial numbers are not displayed is it still possible to differentiate those on the basis of different serial numbers?
The two devices do have distinct serial numbers of course:
I've answered my own question, the answer is no, it cannot differentiate between two identical devices so we cannot Remember a device by vendor,product,serial any more only vendor,product (and probably model because as the following screenshot shows I have two devices enabled with identical vendor,product hence the message Device with duplicate vendor and product must be set to "Remember port" is incorrect). I will check to see if it worked that way before the change.
I notice that in the new 3.2.8 panel, the variables displayed include vendor,product,model whereas before it was vendor,product,serial. The latter ties in with the option to remember device (by vendor, product, serial). If I put two similar devices in, the vendor,product,model will be identical but even though the serial numbers are not displayed is it still possible to differentiate those on the basis of different serial numbers?
The two devices do have distinct serial numbers of course:
Code:
Bus 001 Device 010: ID 0403:6001 Future Technology Devices International, Ltd FT232 Serial (UART) IC
idVendor 0x0403 Future Technology Devices International, Ltd
idProduct 0x6001 FT232 Serial (UART) IC
bcdDevice 6.00
iManufacturer 1 FTDI
iProduct 2 FT232R USB UART
iSerial 3 AQ02Z7EX
Bus 001 Device 009: ID 0403:6001 Future Technology Devices International, Ltd FT232 Serial (UART) IC
idVendor 0x0403 Future Technology Devices International, Ltd
idProduct 0x6001 FT232 Serial (UART) IC
bcdDevice 6.00
iManufacturer 1 FTDI
iProduct 2 FT232R USB UART
iSerial 3 A904NAOGI've answered my own question, the answer is no, it cannot differentiate between two identical devices so we cannot Remember a device by vendor,product,serial any more only vendor,product (and probably model because as the following screenshot shows I have two devices enabled with identical vendor,product hence the message Device with duplicate vendor and product must be set to "Remember port" is incorrect). I will check to see if it worked that way before the change.