2023-08-05, 10:39 PM
Hi,
I’ve tried both ways, powering the board using the module and I was originally using my power supply in the photo. In that photo I had yellow seatalk data and the black wire connected to red on the seatalk network. As soon as I held the resistor across R22 the data went from nothing to receiving data. I then solder it, tested again before switching to the power module and removing usb power.
I’ve tried both ways, powering the board using the module and I was originally using my power supply in the photo. In that photo I had yellow seatalk data and the black wire connected to red on the seatalk network. As soon as I held the resistor across R22 the data went from nothing to receiving data. I then solder it, tested again before switching to the power module and removing usb power.