2023-08-24, 07:17 PM
(This post was last modified: 2023-08-25, 05:25 PM by winkaj.
Edit Reason: solved
)
(2023-08-24, 10:54 AM)yoenn Wrote: Just FYI - I finally managed to perform the calibration successfully. I found the solution on an older thread on this forum: I had pypilot configured in "IMU Only" mode, since I did not have my arduino available yet. Changing this to "Autopilot" mode allowed me to perform the calibration as expected.
@seandepagnier, it might be useful to add some warning popup to inform users that the calibration cannot work if autopilot mode is not enabled.
Regards
What do i have to do , when i dont have a Autopilot , for getting calibration ?
i find away to ignorer uart , it looks like i can calibrate .. now i need to get to my boat to swing it .
Sailing in a LM23 23" motor sailor i Danmark . Mostly In Koege bay .
Harbored in SF-Syd , Copenhagen .
Marine Enginer , Pt. working on power plant
Harbored in SF-Syd , Copenhagen .
Marine Enginer , Pt. working on power plant