2023-10-21, 11:17 AM
I2C no data in SignalK
Somehow I got a strange problem. I'm running I2C 3.3.12 an installation from scratch. I added BME280. Sensors are detected by I2c. Read/Write access confirmed in SignalK. I2C ID is shown under "connection activity" but I'm getting no data regarding Temp. Hum. or Pressure. In log is no error, just the confirmation that the sensor is detected. Any help is highly appreciated.
If you need any additional information, please let me know. I'm a little desperate ....
Thank you.
Somehow I got a strange problem. I'm running I2C 3.3.12 an installation from scratch. I added BME280. Sensors are detected by I2c. Read/Write access confirmed in SignalK. I2C ID is shown under "connection activity" but I'm getting no data regarding Temp. Hum. or Pressure. In log is no error, just the confirmation that the sensor is detected. Any help is highly appreciated.
If you need any additional information, please let me know. I'm a little desperate ....
Thank you.