This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Control Raymarine autopilot from OpenPlotter
#10
I used it with an N2K network and it worked fine. You may need to use the nmea0183-to-nmea0183 forwarding plug in to send $APB, $RMB, $RMC, and possibly $XTE to a port called “seatalkout” as defined in the autopilot config. Then you’ll be getting the data out to the autopilot plugin. If it doesn’t work after that, then go back you your wiring set up.
Reply


Messages In This Thread
RE: Control Raymarine autopilot from OpenPlotter - by SCarns - 2023-12-26, 05:28 PM

Forum Jump:


Users browsing this thread: 5 Guest(s)