2024-01-21, 01:22 PM
Hello Sean
I have been sailing in recent days with version 0.44 and I still had a few rare blockages in the gain tuning fields with the tablet. Everything returns to normal by closing the browser and logging it again.
I can't set the automatic tack. I previously had an FF gain of 1.6 with version 0.24. I could turn quickly and precisely by pressing the +/-10 button 9 times. With the new tacking, the boat exceeds by 20 or 30° even if I reduce the FF gain a lot. But the boat then changes course too slowly by pressing a key 10
After changing from 0.24 to 0.4, some buttons pressed on 433MHz remote controls are sometimes not decoded even if pressed for a long enough time. They are received because the blue LED lights up on the hat. I also have some difficulty programming the +1 and -1 keys although less than with 0.42 and 0.43.
The hat is that of 2021. Should we change the arduino code to Pypilot 024 at 0.4?
I tried to update the arduino code using a PI 4 with the method described in the wiki. But there has always been a failure.
Fortunately, Pypilot still steers just as well with a lot of sea. In addition, it is incredible how little current it consumes with an old Autohelm tiller drive.
I have been sailing in recent days with version 0.44 and I still had a few rare blockages in the gain tuning fields with the tablet. Everything returns to normal by closing the browser and logging it again.
I can't set the automatic tack. I previously had an FF gain of 1.6 with version 0.24. I could turn quickly and precisely by pressing the +/-10 button 9 times. With the new tacking, the boat exceeds by 20 or 30° even if I reduce the FF gain a lot. But the boat then changes course too slowly by pressing a key 10
After changing from 0.24 to 0.4, some buttons pressed on 433MHz remote controls are sometimes not decoded even if pressed for a long enough time. They are received because the blue LED lights up on the hat. I also have some difficulty programming the +1 and -1 keys although less than with 0.42 and 0.43.
The hat is that of 2021. Should we change the arduino code to Pypilot 024 at 0.4?
I tried to update the arduino code using a PI 4 with the method described in the wiki. But there has always been a failure.
Fortunately, Pypilot still steers just as well with a lot of sea. In addition, it is incredible how little current it consumes with an old Autohelm tiller drive.