2023 beta image

[fgorina]

I finally installed the beta to solve some connection problems and I continue having them:
- Usually at the beginning all connects ok and the pings and ssh to tinypilot work
- Sometimes it gets disconnected and then I must wait quite some time to reconnect.

PING 192.168.1.3 (192.168.1.3): 56 data bytes
Request timeout for icmp_seq 0

arp 192.168.1.3
? (192.168.1.3) at (incomplete) on en1 ifscope [ethernet]

Forcing then the arp table it works:

sudo arp -s 192.168.1.3 b8:27:eb:df:89:d4
arp 192.168.1.3
? (192.168.1.3) at b8:27:eb:df:89:d4 on en1 permanent [ethernet]

ping 192.168.1.3
PING 192.168.1.3 (192.168.1.3): 56 data bytes
64 bytes from 192.168.1.3: icmp_seq=0 ttl=64 time=11.366 ms

Connection to WiFi is OK

wlan0 Link encap:Ethernet HWaddr B8:27:EBF:894
inet addr:192.168.1.3 Bcast:192.168.1.255 Mask:255.255.255.0
inet6 addr: fdc6:d547:5dad:0:ba27:ebff:fedf:89d4/64 Scope:Global
inet6 addr: 2a0d:3344:2394:1400:ba27:ebff:fedf:89d4/64 Scope:Global
inet6 addr: fe80::ba27:ebff:fedf:89d4/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1

wlan0 IEEE 802.11 ESSID:"elrond"
Mode:Managed Frequency:2.412 GHz Access Point: E0:63A:B4:698
Bit Rate=72.2 Mb/s Tx-Power=31 dBm
Retry short limit:7 RTS thr:off Fragment thr:off
Power Management:on
Link Quality=70/70 Signal level=-37 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0

I modified /opt/wpa_supplicant.conf to set the country code to ES (I am in Spain and the routers are configured as ES) but no change

I am using the tinypilot_beta_2024_01_14.img tha I think is the last.