This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Pypilot in OpenPlotter 4 released
#21
Do not worry, those ICM-20948 modules are ready for 3.3V: "VDD operating range of 1.71V to3.6V"

I think your intermittent issues mean a previously damaged module or bad contact.
Reply


Messages In This Thread
Pypilot in OpenPlotter 4 released - by Sailoog - 2024-04-14, 08:22 PM
RE: Pypilot in OpenPlotter 4 released - by TVR - 2024-04-15, 12:53 PM
RE: Pypilot in OpenPlotter 4 released - by PaddyB - 2024-04-15, 08:33 AM
RE: Pypilot in OpenPlotter 4 released - by PaddyB - 2024-04-15, 09:27 PM
RE: Pypilot in OpenPlotter 4 released - by PaddyB - 2024-04-16, 06:15 PM
RE: Pypilot in OpenPlotter 4 released - by Lazzz - 2024-04-22, 05:54 AM
RE: Pypilot in OpenPlotter 4 released - by Sully - 2024-04-22, 09:40 AM
RE: Pypilot in OpenPlotter 4 released - by Sully - 2024-04-23, 04:27 PM
RE: Pypilot in OpenPlotter 4 released - by Lazzz - 2024-04-24, 12:02 AM
RE: Pypilot in OpenPlotter 4 released - by Opie91 - 2024-04-24, 01:10 AM
RE: Pypilot in OpenPlotter 4 released - by Lazzz - 2024-04-24, 01:22 AM
RE: Pypilot in OpenPlotter 4 released - by Lazzz - 2024-04-25, 01:17 AM
RE: Pypilot in OpenPlotter 4 released - by Sailoog - 2024-04-24, 05:36 PM
RE: Pypilot in OpenPlotter 4 released - by Lazzz - 2024-05-09, 03:11 AM
RE: Pypilot in OpenPlotter 4 released - by Lazzz - 2024-05-10, 09:56 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)