Need help debugging OpenPlotter crashes

[bitsailor]

Hi Sailoog,

Thanks for the quick response.

With the Actisense-NG1 disconnected, openplotter does not have any issues when the engine is turned on. In addition, turning the instruments on/off (which activates the NMEA bus) also has no effect. 

The issue only happens when the Actisense is connected and the engine is turned on, and the only variable that changes at this point is NMEA data being collected.

Perhaps this is still causing some wierd edge-case power issue, but if that was the case wouldnt the 'get_throttled' command show something other than 0x00?

I am still trying to find if there are additional places I can look for logs/clues?

Thanks