This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
How do I control my AH800 wirelessly
#1
A bit of history. I have an old AH800 which I have just replaced with a simrad tp10.
The AH 800 was dying but the motor still works fine. I had the idea of replacing the electronics with
a pi zero 2 w and a motor controller- driver board. I have just ordered them from amazon.
Just realised I don't have a clue how to connect them up so that I could control it.
I have a rpi4 with a daisy hat supplying AIS and a GPS receiver. I use signalk to send
to my android tablet running Navionics app.

Anybody got any ideas.

I would assume I should use pypilot but should it be running on the pi zero or on the signalk server.


help

Mick
Reply


Messages In This Thread
How do I control my AH800 wirelessly - by mcgarrydware - 2024-07-04, 02:08 PM

Forum Jump:


Users browsing this thread: 4 Guest(s)