2024-07-10, 10:40 AM
Hi,
Thanks for sharing this case design.
It seemed to work and fit, but I had to make some adjustments to get it to fit with the case closed.
I'm using a RPi 5, with Pomoroni NVME BASE, MacArthur with the power module, and also the RTC battery for the RPi 5.
Unfortunately, I had to grind off a bit of what looks like feet on the bottom where the NVME Base sits as there was not enough clearance for the screws that mount the Pomoroni NVME Base to the RPi 5.
Since I had already printed it. it was easier to use my Dremel to grind a bit to make it all fit than to try to adjust the design and reprint.
The grinding caused a bit of a problem with two of the cover screws, but in the end, I was able to make it fit together.
Perhaps make some adjustments to this? It may need a few more venitilation holes also. I haven't evaluated it under use yet.
Again, thanks for sharing your design!
Thanks for sharing this case design.
It seemed to work and fit, but I had to make some adjustments to get it to fit with the case closed.
I'm using a RPi 5, with Pomoroni NVME BASE, MacArthur with the power module, and also the RTC battery for the RPi 5.
Unfortunately, I had to grind off a bit of what looks like feet on the bottom where the NVME Base sits as there was not enough clearance for the screws that mount the Pomoroni NVME Base to the RPi 5.
Since I had already printed it. it was easier to use my Dremel to grind a bit to make it all fit than to try to adjust the design and reprint.
The grinding caused a bit of a problem with two of the cover screws, but in the end, I was able to make it fit together.
Perhaps make some adjustments to this? It may need a few more venitilation holes also. I haven't evaluated it under use yet.
Again, thanks for sharing your design!