2024-07-23, 03:36 AM
To make your Navman 3100 autopilot work without its display using OpenPlotter:
1. Get a NMEA 0183 to USB Converter: Connect the autopilot's NMEA 0183 output to this converter.
2. Install and Configure OpenPlotter: Set up OpenPlotter on your device (e.g., Raspberry Pi).
3. Connect and Configure: Plug the USB converter into your OpenPlotter device and configure the serial port settings.
4. Test and Adjust: Use OpenPlotter to monitor autopilot data and send commands as needed.
Ensure compatibility and refer to manuals for specific setup details.
1. Get a NMEA 0183 to USB Converter: Connect the autopilot's NMEA 0183 output to this converter.
2. Install and Configure OpenPlotter: Set up OpenPlotter on your device (e.g., Raspberry Pi).
3. Connect and Configure: Plug the USB converter into your OpenPlotter device and configure the serial port settings.
4. Test and Adjust: Use OpenPlotter to monitor autopilot data and send commands as needed.
Ensure compatibility and refer to manuals for specific setup details.