|
editing ic2 value clears all sensors
|
2024-09-17, 10:04 PM
I had very strange behavior on the i2c bus with an RPI5. It would not tolerate any run greater than 200mm and once I broke the 4-5 mark on i2c devices it became very unstable and acted erratic.
Adding an Adafruit LTC 4311 Active I2C terminator resolved the issue. May not be your problem but it is worth a try. |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
editing ic2 value clears all sensors - by desolina_nz - 2024-09-01, 08:13 AM
RE: editing ic2 value clears all sensors - by Sailoog - 2024-09-01, 10:31 AM
RE: editing ic2 value clears all sensors - by Kit_buyer - 2024-09-13, 06:03 AM
RE: editing ic2 value clears all sensors - by baltika_no_9 - 2024-09-13, 08:46 PM
RE: editing ic2 value clears all sensors - by Kit_buyer - 2024-09-15, 04:03 PM
RE: editing ic2 value clears all sensors - by SY_Aemy - 2024-09-17, 05:55 PM
RE: editing ic2 value clears all sensors - by Opie91 - 2024-09-17, 10:04 PM
|
