2016-05-12, 06:17 PM
(2016-05-12, 06:13 PM)alekoy Wrote:(2016-05-11, 08:23 PM)Alpenskipper Wrote: Thank you for the information about the glued display frame.
There is a PDF with the technical drawing in the net. I made a dxf File out of this. If you want, I can give you the dxf, or the g-code for the mill.
A DXF would be great!
where did you find the PDF? I have looked on the official raspberry pages etc..
My email is aleksander@oyen.in
Thanks!
https://www.dropbox.com/s/kvl3st8pdth0ha...5.pdf?dl=0