2018-10-17, 01:15 PM
Hello Everyone,
I have an issue using OpenCPN through OpenPlotter. I have tried both methods described here: http://www.sailoog.com/blog-categories/openplotter-rpi I have updated both openplotter and opencpn. OpenPlotter seems to work find but I cannot start OpenCPN! I tried on 2 different rapsberry (3B and 3B+, SD 16GB) But I have the same issue.
When I try to double click on the icon nothing happens. When I type opencpn in the command line I get the message : SEGMENTATION FAULT
I tied to run it through the software ddd and here is what I get:
(gdb) run opencpn
Starting program: /usr/bin/opencpn opencpn
[Thread debugging using libthread_db enabled]
Using host libthread_db library "/lib/arm-linux-gnueabihf/libthread_db.so.1".
Program received signal SIGSEGV, Segmentation fault.
0x004032c4 in cm93chart::CreateHeaderDataFromCM93Cell() ()
(gdb)
I also tried to uninstall then reinstall OpenCPN without any luck...
Hope you can shed some light on this.
Thanks in advance,
Pierre
I have an issue using OpenCPN through OpenPlotter. I have tried both methods described here: http://www.sailoog.com/blog-categories/openplotter-rpi I have updated both openplotter and opencpn. OpenPlotter seems to work find but I cannot start OpenCPN! I tried on 2 different rapsberry (3B and 3B+, SD 16GB) But I have the same issue.
When I try to double click on the icon nothing happens. When I type opencpn in the command line I get the message : SEGMENTATION FAULT
I tied to run it through the software ddd and here is what I get:
(gdb) run opencpn
Starting program: /usr/bin/opencpn opencpn
[Thread debugging using libthread_db enabled]
Using host libthread_db library "/lib/arm-linux-gnueabihf/libthread_db.so.1".
Program received signal SIGSEGV, Segmentation fault.
0x004032c4 in cm93chart::CreateHeaderDataFromCM93Cell() ()
(gdb)
I also tried to uninstall then reinstall OpenCPN without any luck...
Hope you can shed some light on this.
Thanks in advance,
Pierre