Is it possible to connect openplotter to resistive motor sensors? would be great to get coolant temp, oil pressure , turbo pressure and so on. and stndard tank sensors.
Most sensors operate in a 0-500 ohms range , 10-180 being most common in europe , while 240-30 ohms is most common in the US
here are the faria sensor values:http://faria-instruments.com/site_manuals/IS0085E.pdf
Both 2-wire sensors and one wire (resistance to ground) sensors should be supported , but either one would do.
Come to think of it; what about making a Rpi zero signalK motor interface??
Keep up the great work.
.manitu
Most sensors operate in a 0-500 ohms range , 10-180 being most common in europe , while 240-30 ohms is most common in the US
here are the faria sensor values:http://faria-instruments.com/site_manuals/IS0085E.pdf
Both 2-wire sensors and one wire (resistance to ground) sensors should be supported , but either one would do.
Come to think of it; what about making a Rpi zero signalK motor interface??
Keep up the great work.
.manitu