2016-06-03, 09:34 PM
Yes, but only alpha (v0.9.0) at the moment. What you seek is "Enable bridge to eth0". Also useful for plotter with ethernet connector (gofree mode).
Or to connect a notebook over ethernet to the raspi. (Use a crossover Ethernet cable). I think on a hub you don't need the crossover cable if you have an uplink port.
But you are in the wrong thread/category!
Or to connect a notebook over ethernet to the raspi. (Use a crossover Ethernet cable). I think on a hub you don't need the crossover cable if you have an uplink port.
But you are in the wrong thread/category!