2018-07-04, 01:22 PM
(This post was last modified: 2018-07-04, 01:22 PM by It Paradyske.)
Hi,
When the AP is not active, I can control the rod (I use a ST2000+ as actuator) with the arrow buttons.
However, one keypress already pushes the rod quit far out/in.
How can I reduce this distance that the rod travels?
regards
Hans
When the AP is not active, I can control the rod (I use a ST2000+ as actuator) with the arrow buttons.
However, one keypress already pushes the rod quit far out/in.
How can I reduce this distance that the rod travels?
regards
Hans