2020-02-09, 02:45 AM
Well I have it working. I calculated the Shunt 100 Amp 75 mV in parallel with the onboard shunt.
Had an issue with what i thought was a buck converter, that really was a dressed up lm317t it was eating .110 amps and was very warm... thanks amazon..
added a little .91 oled.
Struggled a bit with the small size of the terminal block on the ina219.. What size of wire should i run? I am using awg 18. to the shunt and awg 22 to the buck converter.
I was going to mount it within a .5m of the battery.
Had an issue with what i thought was a buck converter, that really was a dressed up lm317t it was eating .110 amps and was very warm... thanks amazon..
added a little .91 oled.
Struggled a bit with the small size of the terminal block on the ina219.. What size of wire should i run? I am using awg 18. to the shunt and awg 22 to the buck converter.
I was going to mount it within a .5m of the battery.