This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
using pi gpio outputs / pins arduino
#1
I like to use the GPIO outputs on a raspberry pi to drive an electrical hydraulic pump which allready has two relays for polarisation. I will put in a couple of transistors to drive the relays. But how about the sw? I have no experience with python etc. so do not know how to start.

Anyone experience with using the outputs in OpenPlotter?

Niels.
Reply


Messages In This Thread
using pi gpio outputs / pins arduino - by nvelthuijsen - 2018-09-08, 04:10 PM
RE: using gpio outputs - by affinite - 2018-09-08, 04:46 PM
RE: using gpio outputs - by seandepagnier - 2018-09-08, 06:01 PM
RE: using gpio outputs - by nvelthuijsen - 2018-09-09, 09:58 AM
RE: using gpio outputs - by affinite - 2018-09-08, 09:14 PM
RE: using gpio outputs - by seandepagnier - 2018-09-10, 06:50 PM
RE: using gpio outputs - by nvelthuijsen - 2018-09-11, 12:24 PM
RE: using gpio outputs - by jim321 - 2018-09-11, 02:08 PM
RE: using gpio outputs - by nvelthuijsen - 2018-09-11, 02:23 PM
RE: using gpio outputs - by nvelthuijsen - 2018-09-11, 05:45 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)