This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
OpenMarine › OpenPlotter › How do I...? v
Measurement and alarming for onboard voltage?

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Measurement and alarming for onboard voltage?
Sailoog Offline
Administrator
*******
Posts: 2,854
Threads: 59
Joined: Mar 2016
Reputation: 268
#3
2016-06-29, 01:00 PM
Measuring voltage and current will be possible with the future analog sensors implementation. We have plans of using the SPI interface provided by ADC converters like the MCP3008. But before this, it was important to fully implement signal k protocol to OP because we will have a lot of non NMEA data from, voltage, current, liquid levels, revolutions, flows...
Find
Reply


Messages In This Thread
RE: Measurement and alarming for onboard voltage? - by Sailoog - 2016-06-29, 01:00 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)