This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
OpenMarine › OpenPlotter › How do I...? v
segmentation fault

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
segmentation fault
racoon44 Offline
Junior Member
**
Posts: 2
Threads: 1
Joined: Oct 2018
Reputation: 0
#3
2018-10-22, 12:53 PM
(2018-10-18, 06:09 PM)seandepagnier Wrote: Did you compile opencpn with cmake flag -DCMAKE_BUILD_TYPE=Debug
?

This should help the backtrace.   Where did you get your cm93 charts?

Hello,

I just used Etcher to make the SD card. Shall I run the cmake in the prompt?

I have not install charts yet as open cpn does not even start..

Thanks
Find
Reply


Messages In This Thread
segmentation fault - by racoon44 - 2018-10-17, 01:15 PM
RE: segmentation fault - by seandepagnier - 2018-10-18, 06:09 PM
RE: segmentation fault - by racoon44 - 2018-10-22, 12:53 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)