2019-01-07, 09:19 PM
Dear,
it worked, thanks a lot, so i basically followed some tutorial on the web to connect my sensor to the Raspberry then i had to add a few config in the config file to enable 1wire support on GPIO 4.
I have also added a Web app to show the Signal K temperature on a web page.
It all works for the moment.
So next step is to add more temperature sensors (I think about the fridge and then engine room) but for this i will need to find a way to have very long cables (about 5 meters), does any of you know how to do this?
Thanks,
Gary
it worked, thanks a lot, so i basically followed some tutorial on the web to connect my sensor to the Raspberry then i had to add a few config in the config file to enable 1wire support on GPIO 4.
I have also added a Web app to show the Signal K temperature on a web page.
It all works for the moment.
So next step is to add more temperature sensors (I think about the fridge and then engine room) but for this i will need to find a way to have very long cables (about 5 meters), does any of you know how to do this?
Thanks,
Gary