This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
How can I use Astro Pi Sense Hat
I too am trying to set up Raspberry Pi 3+ with Sense Hat.  The calibration within the PyPilot can see the sensor for heading, pitch and roll and works ok, but I need help getting it into Signal K so that the instuments and sail gauge works etc.  Later I'll be needing help getting my old analog depth/water speed and wind speed/angle sensors working too.  I can also use a recommended USB GPS and AIS VHF dongle that will work without much trouble.  Then I think I'll have a complete chart plotter/navigation system for my 1978 Ericson 27. Thanks for any help that can save me time figuring this stuff. Smile

Messages In This Thread
RE: How can I use Astro Pi Sense Hat - by jim321 - 2019-01-12, 04:38 AM
RE: How can I use Astro Pi Sense Hat - by trumpmech - 2020-11-22, 01:20 AM

Forum Jump:

Users browsing this thread: 1 Guest(s)