Send all signalK event to UDP Port (for using navionics on ipad)

[Slovak]

I went ahead and wrote a plugin for this. @signalk/udp-nmea-plugin should be downloadable shortly.


Sent from my iPhone using Tapatalk

The plugin handles only nmea 0183 data.

What exactly are you trying to accomplish - what would be receiving the n2k data and what format does it expect? Unlike 0183 there is no single common format for transmitting n2k data over other media than canbus.

Are you saying the "Signal K to NMEA 2000" is only for "translating" NMEA 0183 to NMEA 2000?

I'm looking for apps (ie SEAiq) access NMEA2000 data from the network on a specific port. I can see how SK already does that on port 10110 for NMEA0183, but can't figure out how to do the exact same with NMEA2000.

Specifically, I have an AIS unit that is plugged into NMEA 2000 network, and I would like to see AIS targets in SEAiq.

The way I understand it, even though SEAiq is on a mobile device connected to the local network (as is OP/SK), it would act as a consumer of AIS data/sentences, as if it was connected via canbus. Except the port access / wifi connection would replace the physical wired connection.