2019-01-22, 08:27 PM
I thought i could use 3 wires good. I will look for reed switches.
I plan to a a rudder sensor another trip to boat to grab rudder and tiller yo tha.
I have to go and pull my 1977 water speed though hull sensor and repair it any ways
Where is the code for the RPiZero. I have a fare bit of space in the Marinepilot after removing the old control board.
I was hopping that your were going to tell me i could just send a command to the motor controller to have it move it to a start position.
I plan to a a rudder sensor another trip to boat to grab rudder and tiller yo tha.
I have to go and pull my 1977 water speed though hull sensor and repair it any ways
Where is the code for the RPiZero. I have a fare bit of space in the Marinepilot after removing the old control board.
I was hopping that your were going to tell me i could just send a command to the motor controller to have it move it to a start position.