This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Switching on a Bilgepump
#4
If you set an output to activate a pump, this will be on until you set the output off by another action. You should add an action to your switch to set the output on when the switch is closed and another action to set the output off when the switch is closed. A float switch will do this nicely.
Reply


Messages In This Thread
Switching on a Bilgepump - by mmo - 2016-07-18, 10:02 PM
RE: Switching on a Bilgepump - by Sailoog - 2016-07-19, 12:25 PM
RE: Switching on a Bilgepump - by mmo - 2016-07-19, 01:37 PM
RE: Switching on a Bilgepump - by Sailoog - 2016-08-02, 01:17 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)