I'm preparing to transfer a config to someone else, so I am struggling to clean accounts ans Passwords
- recorded password in Chromium : cleaned ! (may be my mistake)
- Signal k node server : no access possible, openplotter/openplotter doesn't work neither openplotter/pre ! Is there a possibility to reset other than force an update to 1.2.0 ?
In fact, I would like to set a password distinct from "openplotter".
EDIT : I've forced update 1.2.0 => 1.2.0, hope it could save the signalK password issue
EDIT 2 : it didn't ! (Murphy's law probably ...). Which leaves me with 2 options:
...
...
EDIT 3 : Option 2, Its gone for the night ...
EDIT 4 : After 36402s its done ... Conclusion : A second admin account is required in signal K !
- recorded password in Chromium : cleaned ! (may be my mistake)
- Signal k node server : no access possible, openplotter/openplotter doesn't work neither openplotter/pre ! Is there a possibility to reset other than force an update to 1.2.0 ?
In fact, I would like to set a password distinct from "openplotter".
EDIT : I've forced update 1.2.0 => 1.2.0, hope it could save the signalK password issue
EDIT 2 : it didn't ! (Murphy's law probably ...). Which leaves me with 2 options:
- SHIFT F1, then rebuild the building brick after brick, or
- dd the128 Gb of the SSD, which will take say 12 hours, but will run unassisted ...
...
...
EDIT 3 : Option 2, Its gone for the night ...
EDIT 4 : After 36402s its done ... Conclusion : A second admin account is required in signal K !
Cordialement
Didier B
Pi4, SSD USB3, OP 3.0 Touch SK 3.2.1 OpenCPN 5.8.4 : Thank you Thank you Thank you
Didier B
Pi4, SSD USB3, OP 3.0 Touch SK 3.2.1 OpenCPN 5.8.4 : Thank you Thank you Thank you