2021-06-01, 07:47 AM
Hi,
the TX LED is added since HW 1.5 ;-)
Did you see the Data from OCPN in SignalK Browser?
I did not know your device. But sometimes A/B is vice versa.=> A/B is not standardized. So it is possible that you must switch A/B...
For testing you can connect 2 Ports of the MCS. Then you see on the RX LED on the other port if there is any Data... ;-)
the TX LED is added since HW 1.5 ;-)
Did you see the Data from OCPN in SignalK Browser?
I did not know your device. But sometimes A/B is vice versa.=> A/B is not standardized. So it is possible that you must switch A/B...
For testing you can connect 2 Ports of the MCS. Then you see on the RX LED on the other port if there is any Data... ;-)