2019-06-18, 08:48 AM
Hi Sean,
first of all, thanks for you fantastic work so far.
I installed all the needed hardware and pypilot seems to run.
I can level the sensors and calibrate the compass, ping a full circle.
But I am not able to start the opencpn plugin calibration, it crashes the whole cpn
The compass shows the wrong heading, I am also not able to use the graphical signal k client within cpn to fix this,. The values don't get saved.
Trying to debug on cli shows
_boatimu produces some errors, I will post the log later l. Could the mpu be faulty, even if it shows the heading, pitch and roll.
_servo shows an wx lib error.
_calibration also does not work and produces script errors...
Hope you have some suggestions where to look next.
Thanks
Christian
first of all, thanks for you fantastic work so far.
I installed all the needed hardware and pypilot seems to run.
I can level the sensors and calibrate the compass, ping a full circle.
But I am not able to start the opencpn plugin calibration, it crashes the whole cpn
The compass shows the wrong heading, I am also not able to use the graphical signal k client within cpn to fix this,. The values don't get saved.
Trying to debug on cli shows
_boatimu produces some errors, I will post the log later l. Could the mpu be faulty, even if it shows the heading, pitch and roll.
_servo shows an wx lib error.
_calibration also does not work and produces script errors...
Hope you have some suggestions where to look next.
Thanks
Christian