Hi,
I wanted to use a RPI3B+ in my shipsytem, currently running on RPI3, so I did a new install on USB using noobs in the RPI3B+.
After installation everything Ok, updated using openplotter update button, after update no hdmi connection.
During start-upI see the splash screen, followed by the Noobs recovery page, then start-up auto continues, but screen blanks.
OP can be connected through VNC, sits in low resolutipn and will not change resolution.
Any Ideas?
I wanted to use a RPI3B+ in my shipsytem, currently running on RPI3, so I did a new install on USB using noobs in the RPI3B+.
After installation everything Ok, updated using openplotter update button, after update no hdmi connection.
During start-upI see the splash screen, followed by the Noobs recovery page, then start-up auto continues, but screen blanks.
OP can be connected through VNC, sits in low resolutipn and will not change resolution.
Any Ideas?