2019-08-15, 09:35 AM
(This post was last modified: 2019-08-15, 09:41 AM by jamos.tan@gmail.com.)
Hi Sean,
I've found an article online which helped me understand more about the L289N board in combination with arduino, and an example sketch steering it.
https://www.teachmemicro.com/use-l298n-motor-driver/ and this is also a good one: https://howtomechatronics.com/tutorials/...-h-bridge/
I've also looked at motor.ino more closely, but don't know how to combine the information I've found in the example sketch from the article, and what to change in motor.ino
Hope I am not asking for too much, but I was wondering if you could help me.
I've found an article online which helped me understand more about the L289N board in combination with arduino, and an example sketch steering it.
https://www.teachmemicro.com/use-l298n-motor-driver/ and this is also a good one: https://howtomechatronics.com/tutorials/...-h-bridge/
I've also looked at motor.ino more closely, but don't know how to combine the information I've found in the example sketch from the article, and what to change in motor.ino
Hope I am not asking for too much, but I was wondering if you could help me.