This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Adding MPU9250 OP 2 beta
#11
(2019-12-27, 01:24 PM)ddelorme Wrote:
(2019-12-26, 04:15 PM)Ranur Wrote: I'm stuck here as well have a basic question. Do the MPU-9250 need to attached directly to the Rpi OR can I attach it to a ESP8266 and transfer the data over signal K? this is possible - GREAT! And if so - how?! Right now I think I have attached it in the I2C setup, but it does not show up as detected in pypilot.

It gets set up in Pypilot and no i would not have it connected via wifi ie esp32 or esp8266. I just set my up on rpi4 Pypilot saw the mpu.

Question was more related ro possibility rather than preference. I am wondering if it is POSSIBLE to connect the MPU to an esp8266 and still get valid yaw/roll//pitch sent via signal K to OP.
Reply


Messages In This Thread
Adding MPU9250 OP 2 beta - by Johnnysails - 2019-08-26, 10:11 AM
RE: Adding MPU9250 OP 2 beta - by rastam4n - 2019-08-26, 03:39 PM
RE: Adding MPU9250 OP 2 beta - by Johnnysails - 2019-08-26, 03:50 PM
RE: Adding MPU9250 OP 2 beta - by Sailoog - 2019-08-27, 03:00 PM
RE: Adding MPU9250 OP 2 beta - by Johnnysails - 2019-08-27, 06:57 PM
RE: Adding MPU9250 OP 2 beta - by rastam4n - 2019-09-03, 10:56 PM
RE: Adding MPU9250 OP 2 beta - by Sailoog - 2019-09-04, 03:48 PM
RE: Adding MPU9250 OP 2 beta - by Hub @Code Rouge - 2019-09-04, 05:37 PM
RE: Adding MPU9250 OP 2 beta - by Ranur - 2019-12-26, 04:15 PM
RE: Adding MPU9250 OP 2 beta - by ddelorme - 2019-12-27, 01:24 PM
RE: Adding MPU9250 OP 2 beta - by Ranur - 2019-12-29, 01:19 PM
RE: Adding MPU9250 OP 2 beta - by jim321 - 2019-12-29, 02:53 PM
RE: Adding MPU9250 OP 2 beta - by Ranur - 2019-12-29, 03:23 PM
RE: Adding MPU9250 OP 2 beta - by Ranur - 2020-01-01, 10:09 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)