This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Adding MPU9250 OP 2 beta
#14
Still playing around with this. Disconnected from esp8266 and connected directly tog GPIO on Pi. Pypilot can är aand calibrate, but the 9250 doesn't show up in I2C and I guess that's why I can not get yaw, roll, and pitch as Signal K data. Any pointers?

EDIT:
By adding the info from the Pypilot installera and adding a UDP connection to signal k it seems to be working. Is this the proper way of am I duplicating Signal K data now?
Reply


Messages In This Thread
Adding MPU9250 OP 2 beta - by Johnnysails - 2019-08-26, 10:11 AM
RE: Adding MPU9250 OP 2 beta - by rastam4n - 2019-08-26, 03:39 PM
RE: Adding MPU9250 OP 2 beta - by Johnnysails - 2019-08-26, 03:50 PM
RE: Adding MPU9250 OP 2 beta - by Sailoog - 2019-08-27, 03:00 PM
RE: Adding MPU9250 OP 2 beta - by Johnnysails - 2019-08-27, 06:57 PM
RE: Adding MPU9250 OP 2 beta - by rastam4n - 2019-09-03, 10:56 PM
RE: Adding MPU9250 OP 2 beta - by Sailoog - 2019-09-04, 03:48 PM
RE: Adding MPU9250 OP 2 beta - by Hub @Code Rouge - 2019-09-04, 05:37 PM
RE: Adding MPU9250 OP 2 beta - by Ranur - 2019-12-26, 04:15 PM
RE: Adding MPU9250 OP 2 beta - by ddelorme - 2019-12-27, 01:24 PM
RE: Adding MPU9250 OP 2 beta - by Ranur - 2019-12-29, 01:19 PM
RE: Adding MPU9250 OP 2 beta - by jim321 - 2019-12-29, 02:53 PM
RE: Adding MPU9250 OP 2 beta - by Ranur - 2019-12-29, 03:23 PM
RE: Adding MPU9250 OP 2 beta - by Ranur - 2020-01-01, 10:09 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)