This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Adding MPU9250 OP 2 beta
#15
Hello,


I do have the same problem, the MPU 9250 is connected by I2C using the MarineControlServer and is shown by OpenPlotter I2C adress interface at 69 (a0 connected to vcc) but Pypilot is constantly showing "auto discovery" not showing this sensor.

Any help would be great
Reply


Messages In This Thread
Adding MPU9250 OP 2 beta - by Johnnysails - 2019-08-26, 10:11 AM
RE: Adding MPU9250 OP 2 beta - by rastam4n - 2019-08-26, 03:39 PM
RE: Adding MPU9250 OP 2 beta - by Johnnysails - 2019-08-26, 03:50 PM
RE: Adding MPU9250 OP 2 beta - by Sailoog - 2019-08-27, 03:00 PM
RE: Adding MPU9250 OP 2 beta - by Johnnysails - 2019-08-27, 06:57 PM
RE: Adding MPU9250 OP 2 beta - by rastam4n - 2019-09-03, 10:56 PM
RE: Adding MPU9250 OP 2 beta - by Sailoog - 2019-09-04, 03:48 PM
RE: Adding MPU9250 OP 2 beta - by Hub @Code Rouge - 2019-09-04, 05:37 PM
RE: Adding MPU9250 OP 2 beta - by Ranur - 2019-12-26, 04:15 PM
RE: Adding MPU9250 OP 2 beta - by ddelorme - 2019-12-27, 01:24 PM
RE: Adding MPU9250 OP 2 beta - by Ranur - 2019-12-29, 01:19 PM
RE: Adding MPU9250 OP 2 beta - by jim321 - 2019-12-29, 02:53 PM
RE: Adding MPU9250 OP 2 beta - by Ranur - 2019-12-29, 03:23 PM
RE: Adding MPU9250 OP 2 beta - by Ranur - 2020-01-01, 10:09 AM
RE: Adding MPU9250 OP 2 beta - by Surfer2010 - 2022-02-20, 10:21 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)