2016-03-30, 07:39 PM
(2016-03-30, 09:13 AM)Alpenskipper Wrote: Hi!
Same problem here: Raspi 3 with internal wlan0 and wifi dongle wlan1. Openplotter 0,8
What I tested so far:
Initially wifi sharing runs fine "right out of the box". The internal wlan0 is the AP, the wifi dongle connects to the marina hotspot. When I don' use the wifi, the connection lasts for hours.
But as soon as I use the wifi, the internal AP disappears after a few minutes and does not show up again. A reboot solves the problem.
Further tests:
AP with internal wlan0, wlan1 dongle in USB port, but not connected to hotspot - stable
AP with internal wlan0, wlan1 dongle connected to hotspot, surfing within the Pi3 over vnc - stable
AP with internal wlan0, wlan1 dongle connected to hotspot, sharing the hotspot, surfing with iPad - unstable, AP disappears nearly at once
now the other way round: AP with wifi dongle wlan1 , internal wlan0 connectet to hotspot - stable, but very slow
For me, the problem occurs, when the connection is routed from the hotspot (wlan1 dongle) to the internal wlan0 (AP).
Does anyone have this problem, too?
Martin
Could it be a problem with the marina hotspot?
Is it possible for you to connect to another hotspot, either via a smartphone or if you have wifi at home?
I have just watched a one hour film from Netflix on my Android pad connected via the AP on my pi3 with OP 0.7.1 connected to my wifi at home with a D-Link DWA-131 that uses the Realtek RTL8192SU chip.
I also have an Actisense NGW-1 and a USB GPS connected directly ti the pi, OpenCPN running, sending route information and receiving other info via the NGW-1. Netflix streaming still working without any hickups.