Can't access slew settings

[syohana]

Hi Sean, I did edit servo.max_slew_speed and it just reverted back to the old value ten mins later.

What's worse it is defaults to 100 not the 10-20 range you say is normal.

There seem to be two issues:
1. It is impossible to edit this setting, it just gets reverted back whatever I do.
2. The default value is wrong and makes it impossible to use the pilot with the default settings.

So now I have a pilot I can't use at all...

Surely there must be some way to save this setting and force it to copy to the motor controller too????