2020-01-10, 11:25 AM
Drivers
Installed and working ok
AIS - GNSS
With your current configuration you should get data in signal k and opencpn. If you do not get position or AIS blanks you may have bad reception, satellite coverage, or you are inside a building. Open the NMEA debug window in OpenCPN to check if you get NMEA data.
Why do you want to get AIS and GNSS in pypilot? use this only if you are connecting a pypilot controller. The normal use is creating a signal k connection for the hat in serial app.
Compass - Trim - Heel
The same. Why "autopilot" mode? use "only compass" if you are not using a pypilot controller.
Pressure - Temperature
You have an error in I2C app. You have installed the latest version without removing the old settings as we warned. Open file /home/pi/.openplotter/openplotter.conf and remove any data under [I2C] tag. After configuring the sensors again everything will work including another error you have in network app.
Installed and working ok
AIS - GNSS
With your current configuration you should get data in signal k and opencpn. If you do not get position or AIS blanks you may have bad reception, satellite coverage, or you are inside a building. Open the NMEA debug window in OpenCPN to check if you get NMEA data.
Why do you want to get AIS and GNSS in pypilot? use this only if you are connecting a pypilot controller. The normal use is creating a signal k connection for the hat in serial app.
Compass - Trim - Heel
The same. Why "autopilot" mode? use "only compass" if you are not using a pypilot controller.
Pressure - Temperature
You have an error in I2C app. You have installed the latest version without removing the old settings as we warned. Open file /home/pi/.openplotter/openplotter.conf and remove any data under [I2C] tag. After configuring the sensors again everything will work including another error you have in network app.