2020-11-10, 06:14 PM
I am still having some challenges with the use of switches to control TinyPilot. I am using simple momentary switches off on off.
I have them wired from ex:pin 11 (gpio17 I believe this is to activate AP) to switch terminal, then from the opposite switch terminal I have a 2,4k resistor and then to ground.
Is this correct?
I have them wired from ex:pin 11 (gpio17 I believe this is to activate AP) to switch terminal, then from the opposite switch terminal I have a 2,4k resistor and then to ground.
Is this correct?