2022-09-14, 11:02 PM
I got the same problem. Installed all the latest software and configured the BM280 according to the instructions in the manual.
The connection is configured in SignalK, but I get no data.
I see an open port on 0.0.0.0:51000 (using netstat), but when I connect with "nc" there is no data.
I downloaded the python script from here: https://www.raspberrypi-spy.co.uk/2016/0...in-python/
Using that script I get a proper reading from the sensor. My sensor is at 0x76, as it was noted somewhere that 0x77 does not work with SignalK.
Here is the output:
Chip ID : 96
Version : 0
Temperature : 23.31 C
Pressure : 1011.41716353 hPa
Humidity : 70.4410024284 %
So I assume the chip and connection is actually working.
The connection is configured in SignalK, but I get no data.
I see an open port on 0.0.0.0:51000 (using netstat), but when I connect with "nc" there is no data.
I downloaded the python script from here: https://www.raspberrypi-spy.co.uk/2016/0...in-python/
Using that script I get a proper reading from the sensor. My sensor is at 0x76, as it was noted somewhere that 0x77 does not work with SignalK.
Here is the output:
Chip ID : 96
Version : 0
Temperature : 23.31 C
Pressure : 1011.41716353 hPa
Humidity : 70.4410024284 %
So I assume the chip and connection is actually working.