2020-02-14, 06:10 PM
Good Afternoon,
I am new to all of this so please bare with me. I am putting together my materials etc for adding an RP13 based openplotter system in my 1985 Raider 33. The only working electronics on the boat currently are the depth gauge and I will be getting the speed sensor working once I get the barnacles off. I would like to continue to use the old B&G displays but also want them to be input into the RPi so I can set up my handheld HUD and in-cabin screen. So my question is how can I either output data from the RPi to the B&G displays or can I just pigtail the wires from the sensors and directly input them to the displays and the RPi? ANy information would be greatly appreciated. I have a couple of months before she goes back in the water so I have a little time to work all of this out. Thanks.
I am new to all of this so please bare with me. I am putting together my materials etc for adding an RP13 based openplotter system in my 1985 Raider 33. The only working electronics on the boat currently are the depth gauge and I will be getting the speed sensor working once I get the barnacles off. I would like to continue to use the old B&G displays but also want them to be input into the RPi so I can set up my handheld HUD and in-cabin screen. So my question is how can I either output data from the RPi to the B&G displays or can I just pigtail the wires from the sensors and directly input them to the displays and the RPi? ANy information would be greatly appreciated. I have a couple of months before she goes back in the water so I have a little time to work all of this out. Thanks.
1985 Raider 33 resting in the Hudson Valley, NY