This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Need Help hooking up transducer (DST800)
#1
I have a DST800 Triducer (NMEA 0183) and I am trying to hook it up to my OP V2.  I bought a USB to RS422 adapter.  I hooked up the wires correctly (R+ and R-).  The Recieve LED flashes RED and I have 13V to Transducer.  OP sees it in the serial tab.  I connected it to serial K via the AUTO at 38400 Baud.  In OPEN CPN i added it under connections. But it added it as 4800 baud.  but I am getting no response to temp, depth, or speed.

BTW, I am doing this all in my office before I install.  It is a RPI V3b+, Serial GPS works fine.

I not well versed in this.  I must be missing something.  

Can any one help?  

Thanks!
Edward
Reply


Messages In This Thread
Need Help hooking up transducer (DST800) - by terestron - 2020-02-18, 11:46 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)