This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Moitessier 2 HAT showing as not attached
#1
Hi there, I'm new to this and on a steep learning curve but I'm keen to get it working on my boat.

I installed "2020-01-13-OpenPlotter-Moitessier-HAT-v2.0-pre-release-NOOBS" onto an new Raspberry PI 4 4GB with on a 64GB card. 

I went into Open Plotter -> Moitessier HAT -> Drivers and updated the driver to the latest driver, which shows green against my kernel version.

   

Then I powered down, connected the HAT and then powered back up. Going back into the Moitessier HAT setup I ran the Check System and it shows the HAT not attached as does the Check System run from the toolbar.

   

   

I'm a little confused as some functions of the HAT seem to be working. When I move it around the values for Magnetic Heading, Pitch and Heel seem to change in a way linked to the movement and the Barometric Pressure is changing - it's fallen from 1032 to 1030 over the last couple of hours which is in line with the pressure I am expecting to see (per XCWeather).

   

So on the one hand it's saying it's not connected but on the other some parts of it are working and it has green lights flashing, so clearly it is connected.

If anybody has any suggestions where I should go from here I'd be most grateful.

Thanks very much.

Lindsey
Reply


Messages In This Thread
Moitessier 2 HAT showing as not attached - by lindseygill - 2020-02-23, 05:41 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)