2020-05-23, 02:21 PM
(2020-02-25, 07:42 PM)carlos-palma Wrote:(2020-02-25, 07:21 PM)Sailoog Wrote: Edit /home/pi/.openplotter/openplotter.conf and remove everything under the tag [I2C]
That is your IMU but what is your pressure sensor? check the detected addresses when you can open the I2C app
Thanks, now I2C works and detects the pressure, temperature and humidity as BME280 0/1/2. The pressure is displayed by Open CPN but not the air temperature, will keep checking.
Thanks, that was the problem!!
(2020-02-25, 07:42 PM)carlos-palma Wrote:(2020-02-25, 07:21 PM)Sailoog Wrote: Edit /home/pi/.openplotter/openplotter.conf and remove everything under the tag [I2C]
That is your IMU but what is your pressure sensor? check the detected addresses when you can open the I2C app
Thanks, now I2C works and detects the pressure, temperature and humidity as BME280 0/1/2. The pressure is displayed by Open CPN but not the air temperature, will keep checking.
Thanks, that was the problem!!
Hi!
Change Signal K Key "environment.inside.temperature" to the key "environment.outside.temperature"
select line 1 BME280 > then Edit button
In the new box select Edit button
in the new box select in 'group' > "environment" ,in 'Keys' "outside.temperature" >OK to go back
>OK to go back
Carole