2016-12-07, 06:18 PM
Sailoog, THANK YOU for OpenPlotter! and this new version that incorporates Signal K and Node-Red. I can only guess at the amount of time and work, you and unknown others, put into this effort, thank you.
I usually hangout on the www.crusersform.com /but found this site and thought it may be better to cross post the issue(s) I am finding with 0.9.0 alpha. This forum seems more active with sailloog.
Pi2
GPS-USB
USB-Wifi
X-Y-Z Gyro--Model XXXX???
Pressure/Temp Model XXXX????
LAN and Wifi connections are working limited -BUT- the icon for the LAN connections is greyed out and when trying to configure LAN connections it says "No Connections to Configure". I can still browse the web etc, LAN traffic is working
When in OpenPlotter, no networking connections (TCP/IP) show up to add to KFLEX or to redirect inside SignalK.
It may be that the Pi System does not recognize the LAN under this 0.9.0alpha NOOBS but you cannot configure and get the NEMA 0183 stream onto the TCP/IP and out the door for use on the LAN.
I2C sensors, I noticed the pressure and temp not showing up inside Openplotter now.
NEMA 2K tab, if you check/select which PGNs you want to transmit, the PGNs do not show up in the output box on that tab.
VNC is greyed out within Raspbi Config but works when VNC from remote computer
IC2 temp probe is reconised but cannot get data to transmit. (Maybe I'm still learning the new version)
Everything worked on ver 0.8.0 less the Signal K new items.
I usually hangout on the www.crusersform.com /but found this site and thought it may be better to cross post the issue(s) I am finding with 0.9.0 alpha. This forum seems more active with sailloog.
Pi2
GPS-USB
USB-Wifi
X-Y-Z Gyro--Model XXXX???
Pressure/Temp Model XXXX????
LAN and Wifi connections are working limited -BUT- the icon for the LAN connections is greyed out and when trying to configure LAN connections it says "No Connections to Configure". I can still browse the web etc, LAN traffic is working
When in OpenPlotter, no networking connections (TCP/IP) show up to add to KFLEX or to redirect inside SignalK.
It may be that the Pi System does not recognize the LAN under this 0.9.0alpha NOOBS but you cannot configure and get the NEMA 0183 stream onto the TCP/IP and out the door for use on the LAN.
I2C sensors, I noticed the pressure and temp not showing up inside Openplotter now.
NEMA 2K tab, if you check/select which PGNs you want to transmit, the PGNs do not show up in the output box on that tab.
VNC is greyed out within Raspbi Config but works when VNC from remote computer
IC2 temp probe is reconised but cannot get data to transmit. (Maybe I'm still learning the new version)
Everything worked on ver 0.8.0 less the Signal K new items.