2020-02-27, 02:29 PM
All seems to work fine (latest NOOBS) however I can not get any pressure / temp data from the Moitessier..
The config is pretty much vanilla.
In I2C both pressure and temperature sensors are defined, both from the wane sensor: MS5607-02BA03 with address 0x77.
Also in I2C, connections, there are 2 entries:
the sensor MS5607-02BA03 has a port 51000 connection to SK, name I2C.
The second SK connection is port 20220, no sensor defined, named Pypilot Signal K.
In Signal K both connections are listed and enabled, type SignalK, no logging.
In the new (thank you!) Diagnostic Signal K window I see 4 I2C entries: roll, pitch yaw and magnetic. These come from OpenPlotter.I2C.pypilot.
I do not see any environment (outsdide temperature, outside pressure)
I have not messed around with these settings yet- should I have??
Thanks for your help!
The config is pretty much vanilla.
In I2C both pressure and temperature sensors are defined, both from the wane sensor: MS5607-02BA03 with address 0x77.
Also in I2C, connections, there are 2 entries:
the sensor MS5607-02BA03 has a port 51000 connection to SK, name I2C.
The second SK connection is port 20220, no sensor defined, named Pypilot Signal K.
In Signal K both connections are listed and enabled, type SignalK, no logging.
In the new (thank you!) Diagnostic Signal K window I see 4 I2C entries: roll, pitch yaw and magnetic. These come from OpenPlotter.I2C.pypilot.
I do not see any environment (outsdide temperature, outside pressure)
I have not messed around with these settings yet- should I have??
Thanks for your help!